Audi A4 with 2001- 2005 of release.
1. Operation and car maintenance service
2. The engine
2.1. The general data
2.2. Predvaritlnye checks
2.3. A Mehanichsky part (petrol engines 2,0л)
2.4. Greasing system
2.5. Cooling system
2.6. Injection system
2.7. System of release of the fulfilled gases
2.8. A mechanical part (petrol engines 3,0; 3,2)
2.9. A mechanical part (petrol engines 4,2)
2.9.1. Engine number
2.9.2. Removal and installation semi wedge a belt
2.9.3. Removal and installation damperа крутильных fluctuations
2.9.4. Epiploon replacement crankshaftа on the party of a belt pulley
2.9.5. Removal and installation of a two-mass flywheel
2.9.6. Removal and запрессовка the needle bearing in a flywheel
2.9.7. Removal and installation of a conducted disk
2.9.8. Removal and installation of all covers of chains of a drive
2.9.9. Removal and installation of chains of a drive of camshafts
2.9.10. Removal and installation of a chain drive of the mechanism of management
2.9.11. Removal and installation of a chain of auxiliary drives
2.9.12. An arrangement of loose leaves of the basic bearings on new cranked shaft
2.9.13. An accessory of loose leaves of radical bearings, устанавливаемыхв the block of cylinders
2.9.14. Removal and installation of cam-shafts
2.9.15. Removal and installation of roller levers
2.9.16. Replacement маслосъемных caps
2.9.17. Check of adjustment of phases timing
2.10. A mechanical part (diesel engines 2,0)
2.11. Tables
3. Transmission
4. A running gear
5. The steering mechanism
6. Brake system
7. An onboard electric equipment
8. A body
9. Electric equipment schemes
 







2-9-7-snyatie-i-ustanovka-vedomogo-diska.html

2.9.7. Removal and installation of a conducted disk

Fig. 2.402. Components of a conducted disk: 1 – a conducted disk; 2 – подкладная a washer; 3 – a special bolt; 4 – a compensatory washer; 5 – an epiploon crankshaftа from outside a chain drive; 6 – a cranked shaft



Removal

Fig. 2.316. Clamp installation on a conducted disk


Mark the party of a conducted disk and подкладной the washers, turned to the engine (fig. 2.316).
Establish a key for fixing for untwisting of bolts.
Turn off a conducted disk.

Installation
Establish in return sequence, thus it is necessary consider the following.
Establish a conducted disk with подкладной a washer.
For fastening use new bolts.
Establish a key for fixing for an inhaling of bolts.

The inhaling moment
Conducted disk to crankshaftу*: 30 Нм + 90 **
* Replace bolts.
** 90 correspond to one quarter of a complete revolution.


2.9.6. Removal and запрессовка the needle bearing in a flywheel

2.9.8. Removal and installation of all covers of chains of a drive