Audi A4 with 2001- 2005 of release.
1. Operation and car maintenance service
2. The engine
2.1. The general data
2.2. Predvaritlnye checks
2.3. A Mehanichsky part (petrol engines 2,0л)
2.4. Greasing system
2.5. Cooling system
2.6. Injection system
2.7. System of release of the fulfilled gases
2.8. A mechanical part (petrol engines 3,0; 3,2)
2.9. A mechanical part (petrol engines 4,2)
2.9.1. Engine number
2.9.2. Removal and installation semi wedge a belt
2.9.3. Removal and installation damperа крутильных fluctuations
2.9.4. Epiploon replacement crankshaftа on the party of a belt pulley
2.9.5. Removal and installation of a two-mass flywheel
2.9.6. Removal and запрессовка the needle bearing in a flywheel
2.9.7. Removal and installation of a conducted disk
2.9.8. Removal and installation of all covers of chains of a drive
2.9.9. Removal and installation of chains of a drive of camshafts
2.9.10. Removal and installation of a chain drive of the mechanism of management
2.9.11. Removal and installation of a chain of auxiliary drives
2.9.12. An arrangement of loose leaves of the basic bearings on new cranked shaft
2.9.13. An accessory of loose leaves of radical bearings, устанавливаемыхв the block of cylinders
2.9.14. Removal and installation of cam-shafts
2.9.15. Removal and installation of roller levers
2.9.16. Replacement маслосъемных caps
2.9.17. Check of adjustment of phases timing
2.10. A mechanical part (diesel engines 2,0)
2.11. Tables
3. Transmission
4. A running gear
5. The steering mechanism
6. Brake system
7. An onboard electric equipment
8. A body
9. Electric equipment schemes
 




9975039f


2-9-15-snyatie-i-ustanovka-rolikovykh-rychagov.html

2.9.15. Removal and installation of roller levers

Removal
Remove the engine.
Remove chains of a drive of camshafts from these shaft.
Remove camshafts.
For repeated installation mark conformity of roller levers and their shaft.
Unscrew bolts.
Twist bolt М6 in an aperture of a shaft of roller levers.

Fig. 2.463. Roller levers


Pull together a shaft with ГБЦ and remove roller levers (fig. 2.463).

Installation
Establish in return sequence.

THE NOTE
Replace sealing rings of round section.
Before installation oil points of support рокеров.

Establish cam-shafts.
Establish chains of a drive of camshafts.
Establish the engine.

The inhaling moment
Shaft of roller levers to ГБЦ: 10 Нм.


2.9.14. Removal and installation of cam-shafts

2.9.16. Replacement маслосъемных caps