2.9.5. Removal and installation of a two-mass flywheel

Remove press a coupling disk.

Mark the party of a flywheel turned to the engine.

Fig. 2.321. Запрессовка an epiploon

Establish a key for fixing for untwisting of bolts (fig. 2.321).

Fig. 2.112. Installation of the central bolt in crankshaft

THE NOTE Not to admit damage of a two-mass flywheel at removal, bolts In cannot be unscrewed pneumatic винтовертом (fig. 2.112). To unscrew bolts it is authorised only by hand.

Turn a two-mass flywheel And so that bolts have risen on the centre concerning apertures.

Watch at twisting of bolts that has not occurred залегание heads of bolts on a two-mass flywheel, otherwise the flywheel will be damaged at a twisting of bolts.

Establish in return sequence, thus it is necessary consider the following.

THE NOTE The needle bearing is located in a flywheel, at replacement of its flywheel follows запрессовать. For fastening use new bolts.

Establish a key for fixing for an inhaling of bolts.

Establish press a coupling disk.

Two-mass flywheel to crankshaftу:

– Length болтов* 22,5 mm: 60 Нм +90 **