2.8.7. Removal and installation of a conducted disk (cars with АКПП)
|Fig. 2.316. Clamp installation on a conducted disk
Mark position of a conducted disk of coupling in relation to the engine.
Turn off a conducted disk of coupling.
Take aligning washer enclosed under it.
Installation is carried out in return sequence.
Establish a conducted disk of coupling with an aligning washer and an adjusting plate (fig. 2.317
For fastening use new bolts.
Rearrange a clamp for an inhaling of bolts.
The inhaling moment
Conducted disk of coupling to a cranked shaft:
– Length of bolts 22,5 мм* – 60 +90 ° **
– Length of bolts 35,0 мм* – 60 Н·м +180 ° ***
– Length of bolts 43,0 мм* – 60 Н·м +180 ° ***
* Replace bolts.
** 90 ° there correspond turn quarters.
*** 180 ° correspond to half of turn.