Audi A4 with 2001- 2005 of release.
1. Operation and car maintenance service
2. The engine
2.1. The general data
2.2. Predvaritlnye checks
2.3. A Mehanichsky part (petrol engines 2,0л)
2.4. Greasing system
2.5. Cooling system
2.6. Injection system
2.7. System of release of the fulfilled gases
2.8. A mechanical part (petrol engines 3,0; 3,2)
2.8.1. Engine number
2.8.2. Removal and installation semi wedge a belt
2.8.3. Removal and installation damperа крутильных fluctuations
2.8.4. Removal and installation of a forward sealing flange crankshaftа with an epiploon crankshaftа
2.8.5. Removal and installation of a two-mass flywheel (cars from a manual transmission)
2.8.6. Removal and запрессовка the needle bearing of a two-mass flywheel (cars from a manual transmission)
2.8.7. Removal and installation of a conducted disk (cars with АКПП)
2.8.8. Epiploon replacement crankshaftа from outside a chain drive
2.8.9. Removal and installation of the left and right covers приводных chains
2.8.10. Removal and installation of the bottom cover driving chains
2.8.11. A camshaft drive
2.8.12. Removal of a chain drive from cam-shafts, removal and installation натяжителя chains
2.8.13. Removal and installation of a chain of a drive of the oil pump and балансирного a shaft
2.8.14. Removal and installation балансирного a shaft
2.8.15. Removal and installation of a cranked shaft
2.8.16. Shatunno-piston group
2.8.17. Check of a radial backlash of rods
2.8.18. Compression check
2.8.19. Removal and installation of cam-shafts
2.8.20. Replacement маслосъемных caps
2.8.21. Check of basic elements with hydrojacks
2.8.22. Check of directing plugs of valves
2.9. A mechanical part (petrol engines 4,2)
2.10. A mechanical part (diesel engines 2,0)
2.11. Tables
3. Transmission
4. A running gear
5. The steering mechanism
6. Brake system
7. An onboard electric equipment
8. A body
9. Electric equipment schemes
 







2-8-17-proverka-radialnogo-zazora-shatunov.html

2.8.17. Check of a radial backlash of rods

Uncover a rod. Clear a cover of the bearing and a radical neck.
Put thread Plastigage according to width of the bearing on a neck and in loose leaves of bearings.
Put on covers of rods and fasten with the moment 30 Нм. Коленвал do not turn.
Again remove covers of rods.
Compare width of thread Plastigage to a scale:
Radial palpation: 0,010–0,052 mm.
The limiting admission of radial palpation: 0,12 mm
Replace bolts шатунных bearings.


2.8.16. Shatunno-piston group

2.8.18. Compression check