Audi A4 with 2001- 2005 of release.
1. Operation and car maintenance service
2. The engine
2.1. The general data
2.2. Predvaritlnye checks
2.3. A Mehanichsky part (petrol engines 2,0л)
2.3.1. Engine removal
2.3.2. Removal and installation semi wedge a belt
2.3.3. Removal and installation of a belt pulley crankshaftа
2.3.4. Removal and installation of a gear belt
2.3.5. Removal and installation of a sealing flange and a flywheel / a conducted disk
2.3.6. Replacement манжетного consolidations crankshaftа on the party of a belt pulley
2.3.7. Removal and installation of a forward sealing flange
2.3.8. Removal and installation of a two-mass flywheel
2.3.9. Removal and installation of a conducted disk
2.3.10. Removal and installation of a cranked shaft
2.3.11. Removal and запрессовка the needle bearing in crankshaft
2.3.12. Removal and asterisk installation
2.3.13. Dismantling and assemblage of pistons and rods
2.3.14. A head of the block of cylinders
2.3.15. Removal and installation of the valve of 1 system of change of phases timing
2.3.16. Removal and installation of a cover of a head of the block of cylinders
2.3.17. Removal of a head of the block of cylinders
2.3.18. Installation of a head of the block of cylinders
2.3.19. Compression check
2.3.20. Repair клапанного the mechanism
2.3.21. Removal and phase shifter installation
2.3.22. Removal and installation of cam-shafts
2.3.23. Replacement маслосъемных caps (at the established head of the block of cylinders)
2.3.24. Check of directing plugs of valves
2.3.25. Replacement манжетного consolidations of a final cam-shaft
2.4. Greasing system
2.5. Cooling system
2.6. Injection system
2.7. System of release of the fulfilled gases
2.8. A mechanical part (petrol engines 3,0; 3,2)
2.9. A mechanical part (petrol engines 4,2)
2.10. A mechanical part (diesel engines 2,0)
2.11. Tables
3. Transmission
4. A running gear
5. The steering mechanism
6. Brake system
7. An onboard electric equipment
8. A body
9. Electric equipment schemes
 







2-3-11-snyatie-i-zapressovka-igolchatogo-podshipnika-v-kolenval.html

2.3.11. Removal and запрессовка the needle bearing in crankshaft

THE NOTE
In engines of cars with a mechanical transmission the needle bearing in crankshaftу should be established. If necessary establish the needle bearing.

Extraction

Fig. 2.129. Extraction of the needle bearing


Take the needle bearing by means of an internal stripper and a countersupport (fig. 2.129).

Запрессовка

Fig. 2.130. Запрессовка the needle bearing


Запрессуйте the needle bearing оправкой or centering оправкой заподлицо (fig. 2.130).
The marked party of the needle bearing should be outside in the established condition.


2.3.10. Removal and installation of a cranked shaft

2.3.12. Removal and asterisk installation