Audi A4 with 2001- 2005 of release.
1. Operation and car maintenance service
2. The engine
3. Transmission
4. A running gear
5. The steering mechanism
6. Brake system
7. An onboard electric equipment
7.1. The general data
7.2. Power supplies system
7.3. The generator
7.4. A starter
7.5. Relay blocks, sockets and safety locks
7.5.1. Removal and installation of the block of management of a combination of devices
7.5.2. Multicontact sockets in the block of management of a combination of devices
7.5.3. Removal and installation of the block of safety locks
7.5.4. Removal and installation of the block of management of an onboard network
7.5.5. Removal and installation of the 9-nested block of the relay
7.5.6. Removal and installation of the 3-nested block of the relay
7.5.7. Removal and installation of the 4-nested block of the relay
7.5.8. Removal and installation left штекерной pads
7.5.9. Removal and installation of the central block of management of system Komfort
7.5.10. Removal and installation right штекерной pads
7.5.11. Removal and installation of a box of the main safety lock in a luggage carrier behind at the left – Audi RS4
7.5.12. Removal and installation of the block of the main safety lock – cars with the accumulator in a motor compartment
7.5.13. The general instructions on repair electricians of the car
7.5.14. Repair of wires of tyre CAN
7.5.15. Breakage of a wire with repair in two places
7.5.16. Repair of contacts in cases of sockets
7.5.17. Mechanical blocking of the case of a socket
7.5.18. Round contacts
7.5.19. Flat contacts to asymmetrical lock uvulas
8. A body
9. Electric equipment schemes
 







7-5-9-snyatie-i-ustanovka-centralnogo-bloka-upravleniya-sistemy-komfort.html

7.5.9. Removal and installation of the central block of management of system Komfort

Removal
Remove an upholstery of a rack And.
Remove a seat of the driver.

THE NOTE
It is not required to remove a seat belt from a seat frame.

Turn away a floor rug.

Fig. 7.102. A cover of the electronic block from outside the driver


Unblock a cover of the electronic block from outside the driver (arrow) and cast away it to the right (fig. 7.102).
Disconnect clips (arrows) and take the central block of management of system Komfort 1 of the electronic block.

Fig. 7.103. Sockets of the electronic block from outside the driver


Disconnect sockets 2–6 (fig. 7.103).

Installation
Establish in return sequence.
Establish an upholstery of a rack And.
Establish a seat of the driver.


7.5.8. Removal and installation left штекерной pads

7.5.10. Removal and installation right штекерной pads