Audi A4 with 2001- 2005 of release.
1. Operation and car maintenance service
2. The engine
3. Transmission
4. A running gear
5. The steering mechanism
6. Brake system
7. An onboard electric equipment
7.1. The general data
7.2. Power supplies system
7.3. The generator
7.4. A starter
7.5. Relay blocks, sockets and safety locks
7.5.1. Removal and installation of the block of management of a combination of devices
7.5.2. Multicontact sockets in the block of management of a combination of devices
7.5.3. Removal and installation of the block of safety locks
7.5.4. Removal and installation of the block of management of an onboard network
7.5.5. Removal and installation of the 9-nested block of the relay
7.5.6. Removal and installation of the 3-nested block of the relay
7.5.7. Removal and installation of the 4-nested block of the relay
7.5.8. Removal and installation left штекерной pads
7.5.9. Removal and installation of the central block of management of system Komfort
7.5.10. Removal and installation right штекерной pads
7.5.11. Removal and installation of a box of the main safety lock in a luggage carrier behind at the left – Audi RS4
7.5.12. Removal and installation of the block of the main safety lock – cars with the accumulator in a motor compartment
7.5.13. The general instructions on repair electricians of the car
7.5.14. Repair of wires of tyre CAN
7.5.15. Breakage of a wire with repair in two places
7.5.16. Repair of contacts in cases of sockets
7.5.17. Mechanical blocking of the case of a socket
7.5.18. Round contacts
7.5.19. Flat contacts to asymmetrical lock uvulas
8. A body
9. Electric equipment schemes
 




9975039f

7-5-6-snyatie-i-ustanovka-3-gnezdovogo-bloka-rele.html

7.5.6. Removal and installation of the 3-nested block of the relay

Removal
Switch off ignition and pull out the ignition key.
Remove a ware compartment from outside the driver.

Fig. 7.95. Fastening the 3-nested block of the relay


Unscrew screws 1 and remove the 3-nested block of the relay 2 (fig. 7.95).

THE NOTE
Poses. 3 and 4 in attention do not accept.


Fig. 7.96. The 3-nested block of the relay


Disconnect blocks of safety locks from the 3-nested block of the relay (fig. 7.96).
Take the relay, management blocks, and then unblock a corresponding payment of the relay.

Installation
Establish in return sequence.
Establish a ware compartment from outside the driver.

The inhaling moment
The 3-nested block of the relay to the central pipe of the forward panel: 3 Нм.


7.5.5. Removal and installation of the 9-nested block of the relay

7.5.7. Removal and installation of the 4-nested block of the relay