4.1.27. Change of tyres

At each change of tyres it is necessary to change the nickelized zolotnik of the gate.

The metal gate and the electronic equipment of a wheel can be used repeatedly.

Remove pressure in the tyre, having unscrewed the nickelized zolotnik of the gate.

Dismantle the tyre.

Execute the visual control on the weakened or damaged parts. At the weakened carving connections replace all вентильный knot.

THE NOTE The damaged electronic equipment of a wheel always replace.

Mount the tyre.

Twist the new, nickelized zolotnik of the gate.

To pump up the tyre, again to twirl a plastic cap.

Execute tyre balancing.

Dismantle the tyre

The tyre обкатайте or wring out.

At use of squeezing shovels at first wring out the tyre on the opposite party from the gate.

Fig. 4.32. A site on which wheel shovels are not applied

Do not apply squeezing shovels in the shaded area a (fig. 4.32).

Squeezing head arrange near to the gate so that it was possible establish an assembly shovel in 30 (b) near to the gate.

Only then wring out the tyre in the field of the gate.

Do not apply squeezing shovels in the field of the gate.

Fig. 4.33. Tyre cave-in

Establish the electronic equipment of a wheel nearby 180 against a squeezing head (fig. 4.33).

Press the tyre into depth of a rim in a point, approximately, 90 from a squeezing head.

Mount the tyre.