2.10.3. Removal and installation semi wedge a belt

Fig. 2.44. Bolts of an exhaust pipe of an independent additional heater

In cars with an additional heater unscrew bolts of an exhaust pipe of an independent / additional heater from шумоизоляционного the screen (fig. 2.44).

Fig. 2.45. Fastening of a forward noise isolation

Loosen the clips 1–3 also remove forward and back шумоизоляционный screens (fig. 2.45).

Fig. 2.474. Removal of a casing of the engine

Remove an engine casing (fig. 2.474).

Unscrew bolts.

Fig. 2.2. An air line

Remove an air line 1 and 2 (fig. 2.2).

Remove a sealant of a motor compartment on a radiator framework.

Fig. 2.475. Fastening of the top part of a protective casing

Remove the top part of a protective casing, having released fixing скобы (fig. 2.475).

THE NOTE Before removal semi wedge a belt mark a direction of a course with a chalk or a felt-tip pen. Change of a direction of a course before a maintained belt can lead to its damage

Fig. 2.476. Tension easing semi wedge a belt

For tension easing semi wedge a belt turn a tension element in a direction of an arrow and fix it with the help send (fig. 2.476).

Remove полиwedge a belt.

Establish components in return sequence.

Fig. 2.477. A contour semi wedge a belt: 1 – гаситель крутильных fluctuations; 2 – a tension element; 3 – the generator; 4 – the hydraulic booster pump; 5 – bypass a roller; 6 – the conditioner compressor

Lay полиwedge a belt on pulleys (fig. 2.477).

Keeping a tension element a wrench, take a stopper and loosen the a tension element.

Check up correctness of a lining semi wedge a belt.

Get the engine and check up a belt course.