6.3.4. A ceramic brake of forward wheels CSIC

Fig. 6.38. A ceramic brake of forward wheels CSIC: 1 – screws for a brake support; 2 – a keeping spring for brake pads; 3 – a directing bolt; 4 – the case of a brake support; 5 – brake pads; 6 – a fixing bolt; 7 – a brake disk; 8 – a guard; 9 – screws for a guard; 10 – a bolt; 11 – the skoba-holder; 12 – the piston of the brake cylinder; 13 – the screw of the holder; 14 – connection of the brake pipeline to a brake hose; 15 – the pipeline of brake system; 16 – an arm of a brake highway; 17 – connection of the brake pipeline to a brake support; 18 – the screw of a directing finger

THE NOTE Always to establish full ремкомплект.

After replacement brake pads some times strongly press a brake pedal in a motionless condition so that brake pads have occupied the position corresponding to their working condition.

For откачки a brake liquid from a broad tank use capacity for pumping out which adjoins only to a brake liquid. The brake liquid is poisonous substance, therefore it in no event cannot be pumped out a mouth through a hose.

ATTENTION Pistons of the brake cylinder have various diameter. At installation into place watch that each piston has been inserted into an aperture corresponding to it in a brake support. Ceramic plugs on the piston of the brake cylinder serve as a heat insulator and should not separate from the piston. At damage of the ceramic plug it is necessary to replace the piston of the brake cylinder from safety reasons.