6-3-11-snyatie-i-ustanovka-opornojj-podushki-dlya-pedali-tormoza.html
6.3.11. Removal and installation of a basic pillow for a brake pedal
|
ATTENTION
To course of a pedal of a brake should not stir additional floor rugs.
|
|
|
Fig. 6.63. Components of a pedal of a brake: 1 – a cross-section beam of the forward panel; 2 – a safety lock (2 pieces); 3 – fingers; 4 – a basic pillow; 5 – the screw with internal шестигранником, 10 Нм; 6 – the module of a pedal of an accelerator; 7 – the combined screw, 25 Нм; 8 – the switch of lanterns of a stoplight; 9 – the coupling switch; 10 – the cylindrical screw, the moment of an inhaling 5 Нм; 11 – the combined screw, 20 Нм; 12 – a brake pedal; 13 – the main cylinder of a drive of coupling; 14 – a press spring; 15 – preservation; 16 – a coupling pedal; 17 – a connecting pin
|
Removal
Remove a ware compartment from outside the driver.
|
|
Fig. 6.64. Twisting of protection against twisting and tip removal
|
Unscrew protection against twisting (the cylindrical screw) 3 on a basic pillow ( fig. 6.64). Compress the tip 2 in a direction of an arrow and disconnect the stoplight switch ( fig. 6.64).
|
|
Fig. 6.14. Поворачивание the switch of stoplights
|
The switch of a stoplight 1 turn to the left on 45 and take ( fig. 6.14).
|
|
Fig. 6.15. Connection of a pedal of a brake and the amplifier of a brake drive
|
Brake pedal disconnect from the amplifier of a brake drive by means of a stripper ( fig. 6.15).
Disconnect lock клипсу 1 on the right party ( fig. 6.65). Take a pin so that release a brake pedal.
Take a brake pedal.
Installation
Enter a pin through a brake pedal.
Protection against twisting (the cylindrical screw) tighten only when lock clip-on earrings are put on.
Establish protection against twisting (the cylindrical screw) 3 on a basic pillow ( fig. 6.64). Mount the stoplight switch.
The further assemblage is carried out in return sequence.
| 