3-3-8-snyatie-i-ustanovka-rukoyatki-selektora-akpp.html
3.3.8. Removal and installation of the handle of selector AKPP
|
THE NOTE
Смажте basic sites and sliding surfaces поликарбамидной greasing.
|
Removal
Translate selector AKPP in position D.
|
|
Fig. 3.103. Vydviganie buttons from selector AKPP handle
|
Turn the plug 1 to the left and push it down to an emphasis ( fig. 3.103).
|
|
Fig. 3.102. Selector AKPP handle: 1 – selector AKPP; 2 – selector AKPP rod; 3 – selector AKPP handle; 4 – the panel; 5 – an insert with symbols; 6 – the printed-circuit board; 7 – jalousie; 8 – directing жалюзей
|
Cautiously put forward the button 2 of the handle of selector AKPP 3 exactly so that was possible to insert a cable collar between the button and the handle ( fig. 3.103).
|
THE NOTE
At all do not pull out the button further, it can lead to damage of the handle of the selector.
|
Fix the button in the extended position by a cable collar, as is shown in drawing.
Remove selector AKPP handle in a direction upwards.
Installation
Installation is carried out in return sequence.
Translate selector AKPP in position D.
|
THE NOTE
For removal of the handle of selector AKPP 3 button 2 should be put forward against the stop and should be fixed a cable collar or the replacement tool from the complete set of delivery of the new handle (fig. 3.103).
If the button through an oversight has not been fixed, it cannot be extended from the handle of selector AKPP by means of mechanical tools. Push out the button the compressed air, using for this purpose a blowing-off pistol.
|
Completely put on the handle 3 selector AKPP – the button 2 is turned to the driver. The handle should enter into a ring groove of the selector thus.
Remove a cable collar or other replacement tool, thus a button drive comes into a vertical groove of selector AKPP. If necessary press the button into selector AKPP handle.
Extend the plug 1 upwards and fix its turn to the right.
| 