3-3-10-snyatie-i-ustanovka-blokiratora.html
3.3.10. Removal and installation блокиратора
|
THE NOTE
It is impossible to break блокиратор.
|
Removal
Disconnect from АКБ a weight wire.
Remove a ware compartment from outside the driver.
Remove an overlay of a steering column.
Remove the module of management of the conditioner.
Remove an ashtray of the average console.
Remove the panel of a drive of inclusion of transfers.
Turn the ignition key in position (ignition is included).
Translate selector AKPP in position P.
Unblock safety bracket 2 lock ski lifts and pull out блокиратор 1 of the ignition switch ( fig. 3.105). Raise a safety spring 4 блокиратора and remove aside a support блокиратора 5 drives of inclusion of transfers and get an eye блокиратора ( fig. 3.105).
Installation
Installation is carried out in return sequence.
Without breaking, lay блокиратор for proof panels of devices.
Turn the ignition key in position (ignition is included).
Insert блокиратор 1 into the ignition switch.
Check up fixing of a lock ski lift 2.
Switch the ignition switch in stopper position (ignition is switched off).
Check up selector AKPP finding in position P.
Insert an eye блокиратора into a finger 3 ( fig. 3.105). A little raise a safety spring 4.
On the right insert a support блокиратора 5 into a drive of inclusion of transfers to fix a safety spring 4 ( fig. 3.105). Adjust блокиратор.
Observe safety measures after joining АКБ.
| 