8.3.4. Windscreen installation

After the termination of a spadework it is necessary to put glue.

Fig. 8.99. Glue drawing

Establish a nozzle all surface 2 on glass (fig. 8.99).

Drawing direction – an arrow (fig. 8.99).

THE NOTE The section of the glutinous platen 1 is defined by an aperture of a nozzle and speed of drawing.

Fig. 8.100. Glue drawing on perimetre

Put glue-hermetic on perimetre according to drawing 8.100.

Consider various distance to glass edge

Insert glass into an aperture by means of two double vacuum captures.

ATTENTION Glass is necessary for inserting during 15 mines after glue drawing as differently its gluing properties will decrease.

Level glass in a cross-section direction.

The distance from edge of glass to a roof framework should make 6 mm of +0,5 mm.

Fig. 8.101. Installation of a water protective overlay

Water protective overlay 1 insert and press against the stop in fixing bracketх 2 only after the lapse of time of hardening of glue (fig. 8.101).

By pressing watch that the sealing edge (arrow) of a water protective overlay adjoined to glass and has not slid off for glass edge.

Fig. 8.102. Label installation

Label (e.g. safety pillows) put on a new windscreen on a former place (fig. 8.102).

The size a = 25 mm.

The size b = 10 mm.