8.3.2. Windscreen removal

Remove screen wiper leads.

Remove an overlay обтекателя.

Take out water taking away guards at the left and on the right, beginning from below, from fixing laths.

Remove a sun-protection peak at the left, in the centre and on the right.

Remove an internal rear-view mirror.

Remove the top overlays of racks And.

Pierce шилом the glutinous platen from within in the left bottom corner of glass.

Fig. 8.89. Протыкание the platen шилом

Pass a string in sewed and to pass through inside (fig. 8.89).

Fig. 8.90. String making under a windscreen

Lay a string under a windscreen on perimetre (fig. 8.90).

Fig. 8.91. An attachment of a thread for are sharp to a bolt (marksman) of fastening of leads of a screen wiper

Attach the end of a thread for are sharp to a bolt (marksman) of fastening of leads of a screen wiper (fig. 8.91).

Insert a protective film between a windscreen and the forward panel.

Fig. 8.92. Realisation of the first cut

The beginning of a thread for are sharp fix in the coil and make the first cut approximately to the glass middle (fig. 8.92).

Fig. 8.93. Coil moving

Move the coil, as is shown in drawing 8.93, and continue резку.

Fig. 8.94. Moving of the coil for liberation of a thread from a by-pass roller

Move the coil, as is shown in drawing 8.94, and establish by-pass a roller.

Cut out glass until the thread does not leave a by-pass roller.

Fig. 8.95. Continuation are sharp

Remove by-pass a roller and continue резку (fig. 8.95).

Fig. 8.96. Installation of a by-pass roller in the top radius of glass

Move the coil, as is shown in drawing 8.96, and establish by-pass a roller in the top radius of glass.

Insert a protective film between a windscreen and a ceiling upholstery.

Cut out glass until the thread does not leave a by-pass roller.

Remove by-pass a roller and continue резку.

Repeat process in the left top and bottom radiuses of glass.

Cut out glass completely.

Take out glass by means of two double vacuum captures.