8.1.11. Removal and installation of rear-view mirror RS4

Fig. 8.20. A safety tape

Before rear-view mirror dismantle stick a door in a zone of a mirror and edge of the case of a mirror with a sticky tape on a textile basis, as is shown in drawing 8.20.

Fig. 8.21. Removal of glass of a mirror

Разблокруйте mirror glass the assembly lever also disconnect штекерные sockets of heating of a mirror and automatic shielding of a mirror (fig. 8.21).

Fig. 8.19. Fastening of the electric motor of a mirror

Turn away bolts (arrows) from adjusting knot of a mirror (fig. 8.19).

At installation tighten bolts the moment 1 Нм.

Take out the electric motor 1 of adjusting knot and disconnect штекерный a socket 2 (fig. 8.21).

Remove an overlay of a mirror from the interior of a door.

Turn away a kombi-bolt of a leg of a mirror.

Take out an external mirror from a door and put it on a door cloth.

Fig. 8.22. Clip bolts

Turn away bolts (arrows) of a clip (fig. 8.22).

THE NOTE To turn away the bottom bolt, enter a face key through an aperture of the central bolt of a leg of a mirror.

Fig. 8.23. Clip extraction

Take out a clip 1 of an aperture in a mirror leg (fig. 8.23).

Slightly fix a mirror leg the central bolt to a door.

Fig. 8.24. Отворачивание bolts of an arm of a mirror

Turn away bolts (4 pieces) from a mirror arm (fig. 8.24).

Fig. 8.25. Extraction of the complete set of wires from a mirror arm

Take out the complete set of wires 2 with tips from an arm of a mirror 1 (fig. 8.25).

Take out an arm of a mirror 1 of the case 2.

Fig. 8.26. Extraction of the complete set of wires from the mirror case

Take out the complete set of wires 1со tips from the case of a mirror 2 (fig. 8.26).

Take out a clip from the mirror case.

Fig. 8.27. Clip extraction

THE NOTE For simplification of installation of a sealant if necessary to use soap щелоком.

At mirror installation on a door spend consolidation 1 by means of an assembly wedge over a leg of a mirror 2.