Audi A4 with 2001- 2005 of release.
1. Operation and car maintenance service
2. The engine
3. Transmission
4. A running gear
5. The steering mechanism
6. Brake system
6.1. Preliminary checks
6.2. Repair of brake system
6.3. Repair of brakes of forward wheels
6.4. System ABS
6.4.1. Instructions on carrying out of repair work with antiblocking system
6.4.2. Antiblocking system (ABS) Bosch 5.7
6.4.3. Removal and installation of the hydraulic block of management
6.4.4. Replacement of the block of management ABS
6.4.5. Removal and installation of the hydraulic block
6.4.6. Removal and installation of components of system ABS on a forward axis
6.4.7. Removal and installation of the gauge of frequency of rotation on a back axis
6.4.8. Removal and rotor installation on a back axis
6.4.9. Removal and rotor installation on a back axis
6.4.10. Removal and installation of the switch of stoplights
6.4.11. Removal and installation of the gauge of cross-section accelerations and the gauge of rotation round a vertical axis
6.4.12. Removal and installation of the gauge of pressure in brake system
6.5. Tables
7. An onboard electric equipment
8. A body
9. Electric equipment schemes
 




9975039f

6-4-7-snyatie-i-ustanovka-datchika-chastoty-vrashheniya-na-zadnejj-osi.html

6.4.7. Removal and installation of the gauge of frequency of rotation on a back axis

Fig. 6.83. System ABS components on a back axis (a forward drive): 1 – a back brake support; 2 – a nave of a wheel with a rotor; 3 – a bolt with a fillet; 4 – a brake disk; 5 – a wheel bolt; 6 – the case of the bearing of a nave of a wheel; 7 – the gauge of frequency of rotation; 8 – a bolt with internal шестигранником; 9 – a bolt, 75 Нм



Removal
Loosen the wheel bolts.
Lift the car.
Remove a wheel.
Switch off ignition.
Unscrew a bolt with шестигранной a head 2

Fig. 6.84. The gauge of frequency of rotation


Take the gauge of frequency of rotation 1 of a rotary fist (fig. 6.84).
Turn off screw Torx 3 and take the holder of a cable

Fig. 6.85. The holder of a cable


Unscrew a bolt with шестигранной a head 1 (fig. 6.85).
Unscrew screw Torx 2 and take the holder of a cable.
Release a wire of the gauge of frequency of rotation from holders.

Fig. 6.86. Fastening of an overlay of the bottom


Remove a bottom overlay (fig. 6.86).
Take from fastening a seat in a back part of a body
On cars Cabrio it is in addition necessary to remove a lateral upholstery.

Fig. 6.87. The holder of a cable and a socket of a wire of the gauge of frequency of rotation


Remove the holder of a cable, disconnect a socket of 1 wire of the gauge of frequency of rotation and to squeeze out a nozzle (from the left and right party an arrangement mirror) (fig. 6.87).

Installation
Installation is carried out in return sequence.
Sealing ring of the gauge of frequency of rotation before installation смажте on perimetre plastic greasing.
Lift the car.
Turn off a wheel.
Take the gauge of frequency of rotation from a rotary fist.
Check up a rotor on presence of pollution and damages.


6.4.6. Removal and installation of components of system ABS on a forward axis

6.4.8. Removal and rotor installation on a back axis