Audi A4 with 2001- 2005 of release.
1. Operation and car maintenance service
2. The engine
3. Transmission
4. A running gear
5. The steering mechanism
6. Brake system
6.1. Preliminary checks
6.2. Repair of brake system
6.3. Repair of brakes of forward wheels
6.4. System ABS
6.4.1. Instructions on carrying out of repair work with antiblocking system
6.4.2. Antiblocking system (ABS) Bosch 5.7
6.4.3. Removal and installation of the hydraulic block of management
6.4.4. Replacement of the block of management ABS
6.4.5. Removal and installation of the hydraulic block
6.4.6. Removal and installation of components of system ABS on a forward axis
6.4.7. Removal and installation of the gauge of frequency of rotation on a back axis
6.4.8. Removal and rotor installation on a back axis
6.4.9. Removal and rotor installation on a back axis
6.4.10. Removal and installation of the switch of stoplights
6.4.11. Removal and installation of the gauge of cross-section accelerations and the gauge of rotation round a vertical axis
6.4.12. Removal and installation of the gauge of pressure in brake system
6.5. Tables
7. An onboard electric equipment
8. A body
9. Electric equipment schemes
 




9975039f


6-4-10-snyatie-i-ustanovka-vklyuchatelya-stop-signalov.html

6.4.10. Removal and installation of the switch of stoplights

THE NOTE
For adjustment the stoplight switch is necessary for removing.
That provide sufficient durability of landing, the switch is authorised to be mounted only once.

Removal
Disconnect a socket.
Remove the switch of a signal of braking by turn to the left on 45 .

Installation
Installation occurs upside-down, thus it is necessary pay attention to following points.
Completely take a pusher of the switch of a signal of braking.

Fig. 6.90. The stoplight switch


Insert the switch fixing ledges 1 and 2 into the provided dredging in an assembly aperture (fig. 6.90).
Remove a compartment, the party of the driver.

THE NOTE
At installation actuating of a pedal of a brake is not supposed.

During input of the brake switch pusher adjustment is carried out automatically.

Fig. 6.91. Installation of the switch of a stoplight


Enter the switch into an assembly aperture, press a pedal and fix turn to the right on 45 (fig. 6.91).
After adjustment of the switch of a stoplight check up, whether the brake pedal rests against a trailer emphasis (free position).


6.4.9. Removal and rotor installation on a back axis

6.4.11. Removal and installation of the gauge of cross-section accelerations and the gauge of rotation round a vertical axis