3-2-9-snyatie-i-ustanovka-stopornykh-vtulok-vala-pereklyucheniya-peredach.html
3.2.9. Removal and installation of lock plugs of a shaft of a gear change at the established transmissionOn cars with an independent heater turn away bolts of an exhaust pipe of an independent/additional heater on шумоизоляционном the screen.
Loosen the clamps 1–3 also remove forward and back шумоизоляционный the screen ( fig. 3.1).
Disconnect штекерный a socket 1 from the switch of lanterns of a backing.
|
|
Fig. 3.74. An arm of a highway of coupling and штекерный a socket of the switch of lanterns of a backing
|
In the presence of an arm of a highway of coupling 2 turn away a bolt and remove an arm ( fig. 3.74). Screw the running screw of the universal tool in the stripper handle.
Establish a stripper on the lock plug (arrow A).
Fix a stripper, having established against the stop the plug.
Beat out the lock plug by means of the universal tool in a direction upwards ( fig. 3.75).
|
THE NOTE
In the same way remove the lock plug (arrow B) (fig. 3.75).
|
Installation
It is a little смажте трансмиссионным oil a pin of lock plugs and an aperture in a check point.
Insert the lock plug (arrow A) into a stripper and put on from above fixing plug.
Establish the lock plug against the stop in a check point by means of the universal tool ( fig. 3.75).
|
THE NOTE
Be convinced that lock plugs are established without a warp.
|
In the same way establish the lock plug (arrow B).
In the presence of an arm of a highway of coupling 2 tighten it together with a connecting cable ( fig. 3.74). Connect штекерный a socket 1 to the switch of lanterns of a backing.
Establish шумоизоляционные screens.
The inhaling moment
Connecting cable with an arm of a highway of coupling on a check point: 23 Нм.
| 