3.2.8. Removal and installation of a pillow of a transmission

Fig. 3.1. Noise isolation fastening

Loosen the clamps 3 (at presence) also remove back шумоизоляционный the screen In (fig. 3.1).

Fig. 3.70. Tightening collars of system of release ОГ

Disconnect system of release ОГ from a tightening collar (fig. 3.70).

Fig. 3.71. Installation of the wooden prorate

Lower a check point the lift of the power unit. Enclose the wooden prorate 1 between a check point and the check point lift (fig. 3.71).

Fig. 3.72. Fastening of the cross-section lever

At first turn away bolts 3, then bolts 2 cross-section levers (fig. 3.72).

Slightly lower a check point.

Turn on both nuts 1 and not up to the end remove the cross-section lever.

Turn away a check point pillow.

Installation is carried out in return sequence.

Fig. 3.73. Fastening of a pillow of a check point

Establish a check point pillow on a check point (fig. 3.73).

Tighten bolts taking into account the inhaling moment.

Tighten the cross-section lever to a pillow of a check point 1.

Raise a check point until it will be impossible to screw bolts 2 (fig. 3.72).

Preliminary wrap bolts 2, then bolts 3 (fig. 3.72).

Elements of system of release ОГ level without a tension.

Establish шумоизоляционный the screen under a check point.

Check point pillow to KPP:23 Нм.

The cross-section lever to a check point pillow: 23 Нм.

Tightening a collar of a reception pipe: 40 Нм.