Audi A4 with 2001- 2005 of release.
1. Operation and car maintenance service
2. The engine
3. Transmission
4. A running gear
5. The steering mechanism
6. Brake system
7. An onboard electric equipment
8. A body
8.1. Hinged elements of a body
8.2. Doors, locks of doors and the roof hatch
8.2.1. Removal and installation of a framework of glass and стеклоподъемника a forward door
8.2.2. Removal and electric motor installation стеклоподъемника
8.2.3. Adjustment of a forward door
8.2.4. Removal of the handle of a door
8.2.5. Removal of the lock of a door
8.2.6. Repair of the central lock
8.2.7. Removal and installation of a framework of glass and стеклоподъемника a back door
8.2.8. Adjustment of a back door
8.2.9. Removal and installation of a wind-shelter guard of the hatch of a roof
8.2.10. Removal and installation sun-protection шторки
8.2.11. Removal and overlay installation
8.2.12. Cover adjustment podemno-sdvizhnogo the hatch
8.2.13. Replacement of a sealant of the panel of the hatch
8.2.14. Clearing of drainage hoses
8.3. Osteklenie bodies
9. Electric equipment schemes
 




9975039f


8-2-1-snyatie-i-ustanovka-ramki-stekla-i-steklopodemnika-perednejj-dveri.html

8.2.1. Removal and installation of a framework of glass and стеклоподъемника a forward door

Removal
Remove a door upholstery.
Disconnect electric штекерные connections.
Remove the electric motor стеклоподъемника.
Turn away bolts 7.

Fig. 8.57. Components стеклоподъемника a forward door: 1 – the frame has flown down; 2 – стеклоподъемник; 3 – a forward door; 4 – screw Torx 32 Нм; 5 – a cap; 6 – an adjusting bolt with a fillet 32 Нм; 7 – an adjusting bolt with a fillet 6 Нм; 8 – screw Torx 10 Нм; 9 – an adjusting bolt with a fillet 32 Нм


Turn away bolts 4, 8 and 10 (fig. 8.57).
Turn away bolts 6 and 9 and take out a framework of glass with стеклоподъемником from a door upwards (fig. 8.57).

Installation
Before installation lower glass in a framework half.
Insert a framework and стеклоподъемник into a door from above.
Insert the top half of profile of consolidation on a door into a glass framework.
Wrap fixing screws in sequence 6; 9; 3; 8 and 10 but not to tighten (fig. 8.57).
By hand tighten bolts with a fillet 6 and 9.
Slightly press the top part of a framework of glass 1 in a direction inside.
Tighten bolts 4 and 8 moment 32 Нм.
Tighten bolts with a fillet 6 and 9 moment 32 Нм.
Tighten a bolt 10 moment 10 Нм.
Tighten fixing bolt (arrow) in a framework has flown down the moment 32 Нм.


8.2. Doors, locks of doors and the roof hatch

8.2.2. Removal and electric motor installation стеклоподъемника