2.5.3. Removal and installation of the water pump

Open a cover of a broad tank of system of cooling.

Fig. 2.54. An engine casing

Remove an engine casing (fig. 2.54).

Fig. 2.44. Bolts of an exhaust pipe of an independent additional heater

In cars with an additional heater unscrew bolts of an exhaust pipe of an independent additional heater from шумоизоляционного the screen (fig. 2.44).

Fig. 2.45. Fastening of a forward noise isolation

Loosen the quick disconnect муфты 1 and 2 also remove a forward noise isolation (fig. 2.45).

Merge cooling liquid.

Remove a gear belt.

Fig. 2.214. Removal of the pump of a cooling liquid

Turn off fixing screws of 1 pump of a cooling liquid 2 and cautiously take it (fig. 2.214).

Remove a sealing ring of round section 3.

Installation is carried out in return sequence.

Clear or process a sealing surface under a sealing ring of round section.

Moisten a new sealing ring 3 cooling with liquid G12 +.

Establish the pump of a cooling liquid 2 (fig. 2.214).

Adjusting position: заглушки on the case should be turned downwards.

Tighten bolts of 1 water pump the moment 15 Нм.

Establish a gear belt.

Establish поликлиновый a belt.

Fill in cooling liquid.

Establish a framework of a radiator with hinged components.

Fig. 2.96. Fastening of the rubber buffer

Lower an emphasis of a support against проворачивания at the expense of a body weight on the rubber buffer and tighten nuts (fig. 2.96).

Establish a casing of a forward bumper.

Check up adjustment of headlights.

The water pump to the block of cylinders: 15 Нм.

Cover of a gear belt to the block of cylinders: 10* Нм.

Emphasis of a shaking support: 28 Нм.