4.4.2. Removal and shock-absorber installation

On cars with Dynamic-Ride-Control (DRC II) empty and fill system.

Remove a wheel.

Remove a twisted spring.

Unscrew a nut 1 and take the screw (fig. without protective sheet).

Unscrew bolts 2.

THE NOTE Локер a wheel arch does not act in film.

Remove the shock-absorber.

Tighten screws 2.

THE NOTE Replace screws and self-stopped nuts of a management in drawings in cuts.

Fig. 4.107. Bolts of fastening of a rack

Watch position of the bottom fastening (fig. 4.107).

Rezinometallichesky hinges (sajlent-blocks) have the limited working range of twisting. Therefore carving connections of levers tighten only on the empty car

Tighten screw connection 1 (a forward drive) or (a full drive).

Establish a twisted spring.

Establish and tighten a wheel.